# Invocation command line:
# /cpu2006/bin/runspec -c cpu2006.1.0.SLES10x64.ic91.em64t.Mar272007 -T all --input ref -n 3 --rate 16 -o all int
# output_root was not used for this run
############################################################################
######################################################
# SPEC CPU2006 Intel SLES10 x64 (64-bit) config file #
# Mar 27 2007 Intel Compiler 9.1 for Linux Intel64   #
######################################################

action      = validate
tune        = base or peak
ext         = cpu2006.1.0.SLES10x64.ic91.em64t.Mar272007
PATHSEP     = /
flagsurl000 = http://www.spec.org/cpu2006/flags/CPU2006_flags.20090714.09.xml

check_md5   = 1
mean_anyway = 1
reportable  = 1

#include: SUT.inc
#  ----- Begin inclusion of 'SUT.inc'
############################################################################
# File to be included into config file for SPEC CPU2006

# This include file specifies the "System Under Test" (Hardware,
# OS, BIOS, etc.)
# Any information about the binaries is elsewhere.

# To avoid conflicts in the numbering of the notes,
# please use only 900 and higher numbers.

#######################################################################
# System information                                                  #
# If some remarks about BIOS or Firmware are needed, place them here. #
#######################################################################

default=default=default=default:
notes_os_000= 'ulimit -s unlimited' was used to set the stacksize to unlimited prior to run
notes_os_005= '/usr/bin/taskset' used to bind processes to CPUs
notes_000=
notes_005= The system bus runs at 800 MHz
notes_010=
notes_030=
notes_035= BIOS configuration:
notes_040= Hardware Prefetch = Enable
# notes909= Adjacent Sector Prefetch = Enable

int=default=default=default:
notes_015= All binaries were built with 32-bit Intel compiler except:
notes_020= 401.bzip2, 456.hmmer and 462.libquantum in peak were built with
notes_025= 64-bit Intel compiler by changing the path for include and library files.

fp=default=default=default:
notes903= All binaries were built with 64-bit Intel compiler except:
notes904= 433.milc, 434.zeusmp, 450.soplex, 470.lbm and 482.sphinx3 in peak were built with
notes905= 32-bit Intel compiler by changing the path for include and library files.

###################################
# About Fujitsu Siemens Computers #
###################################

default=default=default=default:
notes_045=
notes_050= This result was measured on the PRIMERGY RX600 S3. The PRIMERGY RX600 S3 and
notes_055= the PRIMERGY TX600 S3 are electronically equivalent.
notes_060 =
notes_065 = For information about Fujitsu Siemens Computers in your country please see:
notes_070 = http://www.fujitsu-siemens.com/countries

#####################################
# Description Hardware and Software #
#####################################

default=default=default=default:
hw_vendor          = Fujitsu Siemens Computers
hw_model000        = PRIMERGY TX600 S3, Intel Xeon processor 7130M,
hw_model001 = 3.20 GHz
hw_cpu_name        = Intel Xeon 7130M
hw_cpu_char        = 800 MHz system bus
hw_cpu_mhz         = 3200
hw_fpu             = Integrated
#
hw_nchips          = 4
hw_ncores          = 8
hw_ncoresperchip   = 2
hw_nthreadspercore = 2
#
hw_ncpuorder       = 1,2,4 chips
hw_pcache          = 12 K micro-ops I + 16 KB D on chip per core
hw_scache          = 1 MB I+D on chip per core
hw_tcache          = 8 MB I+D on chip per chip
hw_ocache          = None
hw_memory000       = 32 GB (16x2 GB DDR2 PC2-3200R, 2 rank, CAS 3-3-3,
hw_memory001 = with ECC)
hw_disk            = Seagate ST973401SS (SAS 73GB 10 krpm)
hw_other           = None

sw_file            = ReiserFS
sw_state           = Multiuser Runlevel 3

license_num        = 22
test_sponsor       = Fujitsu Siemens Computers
tester             = Fujitsu Siemens Computers
test_date          = May-2007
hw_avail           = Aug-2006
prepared_by        = Fujitsu Siemens Computers
config             = cpu2006.1.0.SLES10x64.ic91.em64t.Mar272007.cfg
# ---- End inclusion of '/cpu2006/config/SUT.inc'

default=default=default=default:
CC  = icc
CXX = icpc
FC  = ifort
OBJ = .o

SMARTHEAP_DIR = /opt/SmartHeap_8_1/lib

submit= MYMASK=`printf '0x%x' \$((1<<\$SPECCOPYNUM))`; /usr/bin/taskset \$MYMASK $command

###########################
# portability & libraries #
###########################

fp=default=default=default:
PORTABILITY = -DSPEC_CPU_LP64

400.perlbench=default=default=default:
CPORTABILITY = -DSPEC_CPU_LINUX_X64

462.libquantum=default=default=default:
CPORTABILITY = -DSPEC_CPU_LINUX

483.xalancbmk=default=default=default:
CXXPORTABILITY = -DSPEC_CPU_LINUX

435.gromacs=default=default=default:
LDPORTABILITY = -nofor_main

436.cactusADM=default=default=default:
LDPORTABILITY = -nofor_main

454.calculix=default=default=default:
LDPORTABILITY = -nofor_main

481.wrf=default=default=default:
CPORTABILITY = -DSPEC_CPU_CASE_FLAG -DSPEC_CPU_LINUX

#########################
# Baseline Tuning Flags #
#########################

int=base=default=default:
COPTIMIZE= -fast
CXXOPTIMIZE= -xP -O3 -ipo -no-prec-div
EXTRA_CXXLIBS= -L$(SMARTHEAP_DIR) -lsmartheap

fp=base=default=default:
OPTIMIZE= -fast

#####################
# Peak Tuning Flags #
#####################

int=peak=default=default:
OPTIMIZE= -fast
EXTRA_LIBS= -L$(SMARTHEAP_DIR) -lsmartheap

PASS1_CFLAGS   = -prof_gen
PASS2_CFLAGS   = -prof_use
PASS1_CXXFLAGS = -prof_gen
PASS2_CXXFLAGS = -prof_use
PASS1_LDFLAGS  = -prof_gen
PASS2_LDFLAGS  = -prof_use

fp=peak=default=default:
OPTIMIZE= -fast

PASS1_CFLAGS   = -prof_gen
PASS2_CFLAGS   = -prof_use
PASS1_FFLAGS   = -prof_gen
PASS2_FFLAGS   = -prof_use
PASS1_CXXFLAGS = -prof_gen
PASS2_CXXFLAGS = -prof_use
PASS1_LDFLAGS  = -prof_gen
PASS2_LDFLAGS  = -prof_use

400.perlbench=peak=default=default:
EXTRA_LIBS= 

401.bzip2=peak=default=default:
CC=/opt/intel/cce/9.1.047/bin/icc -I/opt/intel/cce/9.1.047/include -L/opt/intel/cce/9.1.047/lib
PORTABILITY=-DSPEC_CPU_LP64
EXTRA_LIBS= 
feedback=0

403.gcc=peak=default=default:
basepeak=yes

456.hmmer=peak=default=default:
CC=/opt/intel/cce/9.1.047/bin/icc -I/opt/intel/cce/9.1.047/include -L/opt/intel/cce/9.1.047/lib
PORTABILITY=-DSPEC_CPU_LP64
EXTRA_LIBS= 

462.libquantum=peak=default=default:
CC=/opt/intel/cce/9.1.047/bin/icc -I/opt/intel/cce/9.1.047/include -L/opt/intel/cce/9.1.047/lib
PORTABILITY=-DSPEC_CPU_LP64
EXTRA_LIBS= 

471.omnetpp=peak=default=default:
OPTIMIZE=-xP -O3 -ipo -no-prec-div

483.xalancbmk=peak=default=default:
basepeak=yes

410.bwaves=peak=default=default:
basepeak=yes

416.gamess=peak=default=default:
basepeak=yes

433.milc=peak=default=default:
PORTABILITY= 
CC=/opt/intel/cc/9.1.047/bin/icc -I/opt/intel/cc/9.1.047/include -L/opt/intel/cc/9.1.047/lib

434.zeusmp=peak=default=default:
PORTABILITY= 
FC=/opt/intel/fc/9.1.043/bin/ifort -I/opt/intel/fc/9.1.043/include -L/opt/intel/fc/9.1.043/lib
feedback=0

436.cactusADM=peak=default=default:
basepeak=yes

437.leslie3d=peak=default=default:
basepeak=yes

444.namd=peak=default=default:
basepeak=yes

450.soplex=peak=default=default:
PORTABILITY= 
CXX=/opt/intel/cc/9.1.047/bin/icpc -I/opt/intel/cc/9.1.047/include -L/opt/intel/cc/9.1.047/lib

459.GemsFDTD=peak=default=default:
basepeak=yes

470.lbm=peak=default=default:
PORTABILITY= 
CC=/opt/intel/cc/9.1.047/bin/icc -I/opt/intel/cc/9.1.047/include -L/opt/intel/cc/9.1.047/lib

481.wrf=peak=default=default:
basepeak=yes

482.sphinx3=peak=default=default:
PORTABILITY= 
CC=/opt/intel/cc/9.1.047/bin/icc -I/opt/intel/cc/9.1.047/include -L/opt/intel/cc/9.1.047/lib
feedback=0

#########################
# Used Compilers and OS #
#########################

int=default=default=default:
sw_compiler000   = Intel C++ Compiler for IA32/EM64T application,
sw_compiler001   = Version 9.1 - Build 20070215, Package-ID:
sw_compiler002 = l_cc_p_9.1.047
sw_other         = Smart Heap Library, Version 8.1
sw_base_ptrsize  = 32-bit
sw_peak_ptrsize  = 32/64-bit

fp=default=default=default:
sw_compiler001   = Intel C++ Compiler for IA32/EM64T application,
sw_compiler002   = Version 9.1 - Build 20070215, Package-ID: l_cc_p_9.1.047
sw_compiler003   = Intel Fortran Compiler for IA32/EM64T application,
sw_compiler004   = Version 9.1 - Build 20070215, Package ID: l_fc_p_9.1.043 
sw_other         = None
sw_base_ptrsize  = 64-bit
sw_peak_ptrsize  = 32/64-bit

default=default=default=default:
sw_os000         = 64-Bit SUSE LINUX Enterprise Server 10, Kernel
sw_os001 = 2.6.16.21-0.8-smp on an x86_64
sw_avail         = Mar-2007
sw_auto_parallel = No

######################
# End of config-file #
######################